American access system ADV-1000 Manual de Instruções descarregar pdf (Página 6)

HARNESS COLOR CODES

WHITE 11.5 - 29 volts

WHITE AC or DC

GREEN EARTH GROUND

RELAY A (PRIMARY) CONTROL COLOR CODES

BROWN RELAY (A) COMMON

ORANGE RELAY (A) NORMALLY OPEN (N/O)

BLUE RELAY (A) NORMALLY CLOSED (N/C)

RELAY B (SECONDARY) CONTROL COLOR CODES

(Used only if controlling a second device)

GRAY RELAY (B) COMMON

VIOLET RELAY (B) NORMALLY OPEN (N/O)

YELLOW RELAY (B) NORMALLY CLOSED (N/C)

Hookup Steps

(A). Your unit operates between 11.5 volts minimum and 29 volts AC maximum. Measure your

voltage to make sure it falls within these tolerances. Locate the two white wires on the main harness of

the circuit board and, WITH THE POWER OFF, connect them to the power supply leads. Polarity need

not be observed as the unit is rectified.

(B). Connect the primary device to be controlled to the units primary relay control leads. If you are

connecting to a gate operator or electric door strike use the BROWN and ORANGE leads. If you are

connecting to a mag-lock or any device that requires power in the locked state, use the BROWN and

BLUE leads. (See page 3). If you are interfacing to a secondary device, connect the units secondary

relay control leads to the device.

(C). Double check your connections. When you are sure you have the unit hooked up correctly, apply

power to the unit. If this is the FIRST TIME POWER UP of the unit, the unit will perform self

diagnostics. After each test has passed, the unit will sound a beep. The unit will perform a total of 4

tests. The unit will then flash the LED's several times while it is performing a memory setup. Once all

the tests have passed and the unit is set up correctly, you will hear a good beep from the unit. If the unit

does not perform as above, quickly shut off power to the unit and contact your distributor or American

Access Systmes. NOTE: THE UNIT WILL ONLY PERFORM THE SELF DIAGNOSTICS ON

THE FIRST TIME POWER UP. FROM THERE ON OUT THE UNIT WILL SOUND A GOOD

BEEP EACH TIME POWER IS APPLIED.

Page 5

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sem comentários

American access system ADV-1000 Manual de Instruções Página 6