American access system ADV-1000 Guia do Utilizador descarregar pdf (Página 12)

Speedway Reader IPJ-R1000 for Gen 2 UHF RFID

2.2. Preparing Ethernet (TCP/IP) Connectivity

Connect the reader to your network via the Ethernet port (see Figure 2-3). If your network is capable of communicating to the

reader in its default IP configuration (DHCP), then complete and verify connectivity as described below. Note that the host

computer must be on the same subnet as the reader.

Ethernet

Figure 2-3 Ethernet Connectivity

Connect the computer’s Ethernet port to the Speedway reader using one of the following two methods:

• Use of an Ethernet router or switch with either PC IP address set to a static address within the subnet of the reader

(switch) or router’s DHCP set to provide the PC with an IP address within the reader’s subnet.

• Use of a single Ethernet crossover cable to connect directly to your PC with the PC IP address set to a static value

(e.g., 192.168.1.10) within the subnet of the reader.

To verify correct TCP/IP connectivity ping (using the “ping” command) or traceroute (using the “traceroute” command in a

Linux environment, or the “tracert” command in a Windows environment) the reader’s IP address using the PC’s command

line interface. Once connectivity is established, open the computer’s web browser application and connect to the Speedway

reader’s hosted webpage (see Section 3), and login to complete the Speedway reader configuration. The default login (case-

sensitive) is as follows:

User Name: root

Password: impinj

You’re now ready to configure the network. Proceed to section 3.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 64 65

Sem comentários

American access system ADV-1000 Guia do Utilizador Página 12